Sndyj Three-Joint Desk-Clamp Phone Holder Graphite 65 cm

Overview

A graphite desk-clamp phone holder with three rigid aluminum arm sections joined by three toothed pivot joints. The lower arm attaches to a padded screw clamp for horizontal desk edges. The upper arm ends in one spring-loaded padded jaw holder that rotates through one separate ball joint.

Specifications

• Total Arm Reach: Approximately 65 cm when aligned
• Desk Clamp Range: 15-55 mm edge thickness
• Phone Jaw Range: 62-92 mm device width
• Supported Device Thickness: Up to 13 mm within the jaw pads
• Arm Structure: Three rigid aluminum sections
• Primary Joints: Three toothed pivot joints with three hand knobs
• Holder Joint: One ball joint behind the spring jaw
• Pads: Two desk-clamp pads and two phone-jaw pads
• Product Net Weight: Approximately 1.18 kg

Features

• Rigid arm sections replace a flexible gooseneck
• Three toothed pivots lock through separate hand knobs
• Spring jaw width is separate from desk-clamp opening
• No phone, case, cable, charger, or magnetic ring is supplied

Package Includes

• 1 x Graphite padded desk clamp with screw knob
• 3 x Connected rigid aluminum arm sections
• 3 x Installed toothed pivot joints with hand knobs
• 1 x Padded spring phone jaw with ball joint
• 1 x Hex key

Use and Care

Confirm the furniture edge is stable, flat, within the 15-55 mm clamp range, and able to accept pad pressure without damage. Compare the complete phone and case with the jaw dimensions. Support the device before loosening any knob, use the supplied pads, and tighten each joint without forcing it. Do not mount over people, beds, water, heat, fragile objects, or moving vehicles. This holder does not guarantee against a fall. Wipe dry and stop use if the clamp, screw, arm, joint teeth, knob, ball joint, spring jaw, or pads are loose, bent, cracked, or worn.